RE: Setting up a VLAN

see the hub/switch manual whether it supports it or not.

-----Original Message-----
From: Manish Jain [mailto:[email protected]]
Sent: Friday, September 09, 2005 4:40 PM
To: VLAN
Subject: [VLAN] Setting up a VLAN




Hi,
 I have a setup like

        ----------     eth0
        | Router | ----------------- ISP
        ----------
            |eth1
            |
        ----------
        | | | | | |
        different clients


Now i want to convert this system into the form :

        ----------   eth0
        | Router |----------------------- ISP
        ----------
            |eth1
        ----------------------
vlan10  |   vlan11 |   vlan12 |
       -----              |              -----------------------
      |                   |                                     |
some clients        |                              some other clients
                          |
              some other clients

where vlan10, vlan11 and vlan12 are the Vlan-Id's.

Then i want to make sure that the broadcasts are restricted to there
particular Vlan's
but users in 1 vlan CAN connect to users in another vlan.
Can anyone help me with this ?

Thanks,
Manish.

_______________________________________________
Vlan mailing list
[email protected]
http://www.lanforge.com/mailman/listinfo/vlan