Re: Setting up a VLAN

Hi

you need to check the option will support with the Switch you are using.

if its cisco 2900 and Above does your work

and what distro are you using also important.
and what NIC cards you are using in your Router

if other than cisco Switch you need to check they Support VLAN Trunking and VTP Support

hare
  ----- Original Message ----- 
  From: Manish Jain 
  To: VLAN 
  Sent: Friday, September 09, 2005 4:40 PM
  Subject: [VLAN] Setting up a VLAN




  Hi,
   I have a setup like

          ----------     eth0
          | Router | ----------------- ISP
          ----------
              |eth1
              |
          ----------
          | | | | | |
          different clients


  Now i want to convert this system into the form :

          ----------   eth0
          | Router |----------------------- ISP
          ----------
              |eth1
          ----------------------
  vlan10  |   vlan11 |   vlan12 |
         -----              |              -----------------------
        |                   |                                     |
  some clients        |                              some other clients
                            |
                some other clients

  where vlan10, vlan11 and vlan12 are the Vlan-Id's.

  Then i want to make sure that the broadcasts are restricted to there particular Vlan's
  but users in 1 vlan CAN connect to users in another vlan.
  Can anyone help me with this ?

  Thanks,
  Manish.




------------------------------------------------------------------------------


  _______________________________________________
  Vlan mailing list
  [email protected]
  http://www.lanforge.com/mailman/listinfo/vlan

_______________________________________________
Vlan mailing list
[email protected]
http://www.lanforge.com/mailman/listinfo/vlan