Need some helps

Hello,

      I have some questions regarding how to bridge VLANs and LAN, I
have the following scenarios and configuration, but it dos not seem to
work, please shed some light on it. Thanks!

I have a Linux box which has 2 GNIC (Eth0 and Eth1) and one ATM card

1.) Scenario I

Packets<------->Eth0<--->Eth1.x(VLANs)<--->Internet

#vconfig       add eth1   1
#brctl addbr   br0
#brctl addif   br0  eth0
#brctl addif   br0  eth1.1
#ifconfig      br0 up

2. Scenario II

Host 1(10.10.10.x)--->Eth0<--------->Eth1<---->Host 2 (11.11.11.X)

#brctl addbr br0
#brctl addif   br0  eth0
#brctl addif   br0  eth1
#ifconfig      br0 up

I can ping if and only if Host 1 and Host 2 are in the same domain, say
10.10.10.X. I believe that bridge should be able to bridge traffics
between different network domains, but how?

Any help is much appreciated!

Hai







--
Hai Wang
Principle Software Engineer
Fine Point Technologies, Inc.
139 Centre Street, 6th Floor
New York, New York 10013-4408
email: [email protected]
phone: +1.212.962.7410 x 325
fax: +1.212.962.7404
web: http://www.finepoint.com

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of [email protected]
Sent: Monday, October 10, 2005 10:12 AM
To: Hai Wang
Subject: Welcome to the "Vlan" mailing list

Welcome to the [email protected] mailing list!

To post to this list, send your email to:

  [email protected]

General information about the mailing list is at:

  http://www.lanforge.com/mailman/listinfo/vlan

If you ever want to unsubscribe or change your options (eg, switch to
or from digest mode, change your password, etc.), visit your
subscription page at:

  http://www.lanforge.com/mailman/options/vlan/hwang%40finepoint.com

You can also make such adjustments via email by sending a message to:

  [email protected]

with the word `help' in the subject or body (don't include the
quotes), and you will get back a message with instructions.

You must know your password to change your options (including changing
the password, itself) or to unsubscribe.  It is:

  mbgsbhp8

Normally, Mailman will remind you of your candelatech.com mailing list
passwords once every month, although you can disable this if you
prefer.  This reminder will also include instructions on how to
unsubscribe or change your account options.  There is also a button on
your options page that will email your current password to you.