Re: VLAN and bridging with xen

On Tue, Nov 22, 2005 at 12:39:05AM +1300, Greg Brackley wrote:
> Without the VLAN interface I can get my XEN/bridging networking
> working (but limited by the number of physical interfaces). 
> Without the XEN interfaces I regularly setup VLAN interfaces, as
> well as using 802.3ad bonding. However I seem to be unable to get
> the bridges to XEN interfaces working with VLAN's.

[..]

> 2: vif0.0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue
>     link/ether fe:ff:ff:ff:ff:ff brd ff:ff:ff:ff:ff:ff

This doesn't look like a very good ethernet address. Does that
matter?

Perhaps the xen interface drivers do tricks?


//Peter