Re: Pregunta sobre vlans in english
Alex Zeffertt <[email protected]>
| Newsgroups | gmane.linux.drivers.vlan |
|---|---|
| Organization | Cambridge Broadband Ltd. |
| Message-ID | <[email protected]> |
On Thu, 16 Feb 2006 16:56:58 -0500 (ECT) <[email protected]> wrote: > Hello....I am a student of the one university in Ecuador, > > I want know about the communication between vlans.... > I have: > -1 switch catalyst 2950 > -1 pc with RH fedora core 3 for make the communication as if was a > router-2 vlans configurated in the switch > > what is the best way? with the comand [vconfig], or with the program > [zebra] in the fedora system and what do I do? > To create a vlan device on VID 10, 1. Put the details into /etc/sysconfig/network-scripts/ifcfg-eth0.10 (same format as ifcfg-eth0) (*) 2. Run "ifup eth0" This change will persist after your next reboot. After this point you will have a device eth0.10 which works in exactly the same way as eth0. Alex (*) I am assuming that FC3 works the same way as RH9 here.... > I dont know english too much, forgive me for the errors and > THANK YOU VERY MUCH BY HIS TO HELP US, > GRACIAS POR SU COLABORACION > > > _______________________________________________ > Vlan mailing list > [email protected] > http://www.lanforge.com/mailman/listinfo/vlan