REORDER_HDR always 1??

[email protected] (Carlos Carvalho) Wed, 10 May 2006 20:28:41 -0300

Newsgroups	gmane.linux.drivers.vlan
Message-ID	<[email protected]>

It seems that REORDER_HDR is always one, even without setting it. At
least /proc/net/vlan/eth0.2 shows this:

eth0.2  VID: 2   REORDER_HDR: 1  dev->priv_flags: 1

I tried the command

# ~/vconfig set_flag eth0.2 0

but got

ERROR: trying to set flag on device -:eth0.2:- error: Invalid argument

How should it be done? This is with 2.6.

lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.