Re: newbie question on enabling vlan feature in the driver

Ben,

Thanks for your response. The mac data sheet says, when 0x8100 is written to
the
van1_tag register, the mac compares 13th & 14th bytes of incoming frame and,
if it
finds a match, it sets vlan1 bit in rx status register. However, this
particular status
bit is not actually exposed to driver access. The documentation could be
wrong.

Other than the above, no behaviour changes. In this case, I just simply
ensure
that the driver/chip can handle MTU + 4 bytes? No need to enable
NETIF_VLAN_HW_TX/RX
and related callbacks?

By the way, I don't see my postings @
http://ns2.lanforge.com/pipermail/vlan/2007-March/thread.html.

Thanks
/kmk

On 3/13/07, Muthu Kumar <[email protected]> wrote:
>
> 'm trying to enable VLAN in my eth driver. The eth mac supports
> vlan processing and has a register (vlantag1) that should be written
> with 0x8100 to enable VLAN processing. Other than this, the mac does
> not have any other vlan related registers or anything else. It does not
> give
> any indication during rx if VLAN pkts received.
>
> How do I enable VLAN in my driver for such a MAC? I'm basically
> confused with all the callbacks such as vlan_rx_register etc most
> drivers support.
>
> Currently, in my driver I've enabled the features NETIF_VLAN_HW_TX/RX
> and providing the above callbacks. But I'm not sure whether these flags
> are applicable to my driver.
>
> what else I need to do? I'm kinda stuck here. Any help would be highly
> appreciated.
>
> thx
> /kmk

_______________________________________________
Vlan mailing list
[email protected]
http://www.candelatech.com/mailman/listinfo/vlan