Re: Re: newbie question on enabling vlan feature in the driver

kmk wrote:
> Ben
> 
> I think I was looking at the wrong field in the data dump. I'm
> seeing vlan tags in both directions.
> 
> With writing to vlantag1 register,
> 
> in Tx case I see the following
> 
> veth->h_vlan_proto = 0x8100
> 
> veth->h_vlan_TCI  = 2
> veth->h_vlan_encapsulated_proto = 806
> 
> in Rx case I see the following
> 
> veth->h_vlan_proto = 0x8100
> 
> veth->h_vlan_TCI  = 32a
> veth->h_vlan_encapsulated_proto = 806
> 
> 
> The above was observed on arm board.
> 
> I guess it is working?

I guess so...you can ping now?

Make sure you try UDP and TCP traffic too to make sure any
checksumming issues are resolved.

Ben

-- 
Ben Greear <[email protected]>
Candela Technologies Inc  http://www.candelatech.com