Re: How to support interface vlan trunk

I recently did a similar installation, effectively, provided that LAN 2
and 3 are tagged to eth0 in the switch and the same for eth1 it's enough
to activate
sysctl net.ipv4.ip_forward=3D1

You can also add

net.ipv4.ip_forward =3D 1 in /etc/sysctl.conf

Good luck!

liang jian wrote:
> LAN2 ---- | |----------LAN2
> swith ------trunk------eth0| Linux box| eth1 ------trunk-- switch
> LAN3 ---- | |----------LAN3
> How to support interface vlan trunking on eth0 and eth1 let LAN2 and
> LAN3 vlan data can pass linux box at route settings?
>
>
> -----------------------------------------------------------------------=
-
> =C7=C0=D7=A2=D1=C5=BB=A2=C3=E2=B7=D1=D3=CA=CF=E43.5G=C8=DD=C1=BF=A3=AC2=
0M=B8=BD=BC=FE=A3=A1 <http://cn.mail.yahoo.com>
> -----------------------------------------------------------------------=
-
>
> _______________________________________________
> Vlan mailing list
> [email protected]
> http://www.candelatech.com/mailman/listinfo/vlan
>  =20


--=20
-----------------------------------------------------------------------
   __  ___     ___ ____  __   Jonathan Petersson, Systems Administrator
  /  |/  /_ __/ __/ __ \/ /   Mobile SWE: +46 732 00 1678
 / /|_/ / // /\ \/ /_/ / /__  Phone SWE: +46 18 17 44 31
/_/  /_/\_, /___/\___\_\___/  Mobile US: +1 408 931 3994
       <___/  www.mysql.com   Phone US: +1 408 213 6790
-----------------------------------------------------------------------
     (I'm currently located in Sweden but travels frequently to the US,
              unless I answer my Swedish phones please try the US ones)

	           Are you MySQL certified? www.mysql.com/certification