Re: How to support interface vlan trunk

Ard van Breemen wrote:
> On Wed, Aug 01, 2007 at 11:19:53AM +0200, Jonathan Petersson wrote:
>   
>> I recently did a similar installation, effectively, provided that LAN 2
>> and 3 are tagged to eth0 in the switch and the same for eth1 it's enough
>> to activate
>> sysctl net.ipv4.ip_forward=1
>>     
>
> Unless he expects LAN2 to be bridged to LAN2 :-).
> I was thinking about creating a bridge between eth0.2 and eth1.2,
> and between eth0.3 and eth1.3, and route the bridge interfaces.
>   
I was thinking about that as well, but based on his question I cannot 
really tell if that was what he wanted.

Iiang, if you want to do the bridge look into brctl

To add:

brctl addbr br0
brctl addif br0 eth0.2
brctl addif br0 eth1.2

brctl addbr br1
brctl addif br1 eth0.3
brctl addif br1 eth1.3

To take down:

brctl delbr br0
brctl delbr br1
> Anyway, with this suggestion added, it should be rather easy to
> envision a good solution :-). Or better: to know what to ask next
> :-).
>
> _______________________________________________
> Vlan mailing list
> [email protected]
> http://www.candelatech.com/mailman/listinfo/vlan
>   


-- 
-----------------------------------------------------------------------
   __  ___     ___ ____  __   Jonathan Petersson, Systems Administrator
  /  |/  /_ __/ __/ __ \/ /   Mobile SWE: +46 732 00 1678
 / /|_/ / // /\ \/ /_/ / /__  Phone SWE: +46 18 17 44 31
/_/  /_/\_, /___/\___\_\___/  Mobile US: +1 408 931 3994
       <___/  www.mysql.com   Phone US: +1 408 213 6790
-----------------------------------------------------------------------
     (I'm currently located in Sweden but travels frequently to the US,
              unless I answer my Swedish phones please try the US ones)

	           Are you MySQL certified? www.mysql.com/certification