Fw: 3C2000 built in ASUS P4R800-VM

"Reza Iskandar Achmad" <[email protected]> Wed, 18 Feb 2004 12:54:32 +0700
Newsgroups gmane.linux.drivers.vortex.devel
Message-ID <006301c3f5e3$ae78a7b0$024e2fca@reza>
> Dear All,
> Recently we have purchased a new ASUS P4R800-VM MoBo which is shipped with
3C2000 Gigabit LAN Adapter inside.
>
> We are running Linux Debian 3.0-rev1 on it. Then we tried to activate LAN
> adapter following Installation Instruction that exist in CD we receive
> as ASUS Shipment Package.
>
> The kernel version we are using for the first shoot of this "hard-work" is
> 2.4.18. After compiling the driver package (3c2000.tar.gz) within 2.4.18
> kernel that return no error, then we try to load this module. But it seem
> that we gotta problem, which describe as:
>
> # insmod 3c2000.o
> 3c2000.o: init_module: No such device
> Hint: insmod errors can be caused by incorrect module parameters,
including
> invalid IO or IRQ parameters
>
> We have enable this LAN Adapter in BIOS setting as you can see in output
of
> "lspci -vx" below
>
> 02:08.0 Ethernet controller: 3Com Corporation: Unknown device 9202 (rev
40)
>         Subsystem: Asustek Computer, Inc.: Unknown device 8108
>         Flags: bus master, medium devsel, latency 64, IRQ 18
>         I/O ports at ec00 [size=128]
>         Memory at fe200000 (32-bit, non-prefetchable) [size=128]
>         Expansion ROM at fe100000 [disabled] [size=128K]
>         Capabilities: [dc] Power Management version 2
> 00: b7 10 02 92 17 01 10 02 40 00 00 02 10 40 00 00
> 10: 01 ec 00 00 00 00 20 fe 00 00 00 00 00 00 00 00
> 20: 00 00 00 00 00 00 00 00 00 00 00 00 43 10 08 81
> 30: 00 00 10 fe dc 00 00 00 00 00 00 00 03 01 0a 0a
>
> Realize that this work not run smoothly as ussual, then we try to googling
> over the internet and find update information that 3C2000 is using
> chipset from Syskonnect (sk98xx), so we try to use official Linux module
for
> sk98lin in 2.4.18. But the problem persist.
>
> Until now 3C2000 Lan Adapter not working yet although we have try to
> upgrade the Linux Kernel to 2.4.22 , 2.4.23, 2.4.24 and 2.6.2.
>
> We would be appreciate if anyone can assist us in order to make your
3C2000
> work in our system.
>
> Regards,
>
> Reza Iskandar Achmad
>

_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex