Re: Problem with Nokia ADSL modem/hub and 3c905
Ville Herva <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Jan 24, 2001 at 06:33:30PM -0500, you [Donald Becker] wrote: > On Thu, 25 Jan 2001, Ville Herva wrote: > > > > > eth0: interrupt, status e401, latency 8, cur_rx 317, dirty_rx 317 > > eth0: In interrupt loop, status e401. > > In boomerang_rx(), status e001, rx_status 8000. > > Receiving packet size 60 status 803c. > > eth0: exiting interrupt, status e000. > > eth0: vortex_close() status e000, Tx status 00. > > eth0: vortex close stats: rx_nocopy 137 rx_copy 181 tx_queued 264 Rx > > pre-checksummed 0. > > bridge-eth0: lost peer eth0 > > bridge-eth0: down Just an update: with the same net hardware (3c905a, Nokia ADSL hub M1122), but with new motherboard (Abit ST6R, i815, UP), and new kernel (2.4.18pre3 and its 3c59x.c) the problem still happens: Sep 23 20:33:36 babbage kernel: eth0: transmit timed out, tx_status 00 status e000. Sep 23 20:33:36 babbage kernel: diagnostics: net 0cc0 media 8c02 dma 00000020. Sep 23 20:33:36 babbage kernel: Flags; bus-master 1, dirty 1(1) current 17(1) Sep 23 20:33:36 babbage kernel: Transmit list 00000000 vs. c784b240. Sep 23 20:33:36 babbage kernel: 0: @c784b200 length 8000002a status 8000002a Sep 23 20:33:36 babbage kernel: 1: @c784b240 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 2: @c784b280 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 3: @c784b2c0 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 4: @c784b300 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 5: @c784b340 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 6: @c784b380 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 7: @c784b3c0 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 8: @c784b400 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 9: @c784b440 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 10: @c784b480 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 11: @c784b4c0 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 12: @c784b500 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 13: @c784b540 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 14: @c784b580 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 15: @c784b5c0 length 8000002a status 8000002a Sep 23 20:33:36 babbage kernel: eth0: vortex_error(), status=0xe005 Sep 23 20:33:36 babbage kernel: eth0: Transmit error, Tx status register 90. Sep 23 20:33:36 babbage kernel: Flags; bus-master 1, dirty 1(1) current 17(1) Sep 23 20:33:36 babbage kernel: Transmit list 0784b280 vs. c784b240. Sep 23 20:33:36 babbage kernel: 0: @c784b200 length 8000002a status 8000002a Sep 23 20:33:36 babbage kernel: 1: @c784b240 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 2: @c784b280 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 3: @c784b2c0 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 4: @c784b300 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 5: @c784b340 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 6: @c784b380 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 7: @c784b3c0 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 8: @c784b400 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 9: @c784b440 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 10: @c784b480 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 11: @c784b4c0 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 12: @c784b500 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 13: @c784b540 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 14: @c784b580 length 8000002a status 0000002a Sep 23 20:33:36 babbage kernel: 15: @c784b5c0 length 8000002a status 8000002a (...) This happens when I unplug the cable between 3c905a and M1122 and the replug it. The link light is on at both ends, but I can't ping until I reboot. I'm only reporting this, since I vaguely recall that Andrew said (*) something about an IRQ fix that had went to 2.4ac that should fix this. (Sorry I lost the original mail from Andrew) I guess it wasn't merged in mainline before 2.4.18pre3 got out? -- v -- [email protected] (*) When I first reported this with 2.2.18 or so. _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex