Re: A 3c905B behaving strange
Bogdan Costescu <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <Pine.LNX.4.44.0211151306110.13137-100000@kenzo.iwr.uni-heidelberg.de> |
On Fri, 15 Nov 2002, Antti T J Granqvist wrote: > Now I try to set the card to half-duplex by > rmmod 3c59x > and > insmod 3c59x debug=3 full_duplex=0 The most reliable way to set duplex is with mii-diag. If I'm not mistaken "full_duplex=0" is the default value and means "I don't care"; there was a discussion some time ago about having a flag to force half-duplex, but I don't remember what was the outcome... > link partner capability c000, But this might be a good hub if it reports something back to the card :-) > Also as I mentioned earlier, at cold boot _THIS_ card makes the hub jam > until the driver is loaded. You also said that another card has the same effect on the hub. Or am I messing up different threads ? -- Bogdan Costescu IWR - Interdisziplinaeres Zentrum fuer Wissenschaftliches Rechnen Universitaet Heidelberg, INF 368, D-69120 Heidelberg, GERMANY Telephone: +49 6221 54 8869, Telefax: +49 6221 54 8868 E-mail: [email protected] _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex