Re: A 3c905B behaving strange
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 15 Nov 2002, Bogdan Costescu wrote: > On Fri, 15 Nov 2002, Antti T J Granqvist wrote: > > > You mean like > > mii-diag -F 10baseT-HD? > > Well, your last vortex-diag dump revealed that autonegotiation was > working. So I would say to try first to limit autonegotiation by using > 'mii-diag -A 10baseT-HD' and only then '-F 10baseT-HD' which should > disable autonegotiation. > > Note to Donald: maybe I'm too blind to see it now, but my copy of > mii-diag does not allow to advertise some more complex media combination, > like "10baseT-HD and 100baseTx-HD" which I think might be worth adding. You must pass a numeric value to advertise complex capability sets. Do you have a syntax suggestion for doing otherwise? > > Do I have to reload the driver module without parameters before that? > > Yes, but "debug" is also a parameter and you might want to keep it :-) Make certain that full_duplex is not set in /etc/modules.conf or /etc/conf.modules. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex