Re-Installation of 3c59x

I had mailed this problem on 11/14/2002, but I did not get any reply. I know 
it is a simple problem, but I am not able to figure it out. It will be really 
great if I get some help.

        I am facing difficulties while installing the 3c59x driver for the 
second time.I have a 3c905 NIC. The version of linux kernel is 2.4(RH- 7.3). I 
downloaded the pci-scan.* and 3c59x.c files from the scyld website. First time 
when I install the pci-scan.o and 3c59x.o modules with the "insmod" command, 
the driver gets installed, dhcp gets called and everything works fine. I stop 
the driver by "/etc/rc.d/init/network stop" or "/sbin/ifdown eth0". Then I 
remove the modules using "rmmod". Again if I install the driver with "insmod" 
the modules gets installed but packets are not transmitted, giving a host 
error. I have to restart the machine to make it work again. Apart from 
removing the modules using "rmmod", should I do anything else. Should I do any 
clean up procedures or is there any other way to install and remove modules.


-----Kernel messages after Installing 3c59x for the first time-----------

Nov 12 11:52:57 localhost kernel: 3c59x.c:v0.99X 6/21/2002 Donald Becker, 
[email protected]
Nov 12 11:52:57 localhost kernel: http://www.scyld.com/network/vortex.html
Nov 12 11:52:57 localhost kernel: eth0: 3Com 3c905 Boomerang 100baseTx at 
0xdc80, 00:c0:4f:ae:6c:eb, IRQ 11
Nov 12 11:52:57 localhost kernel: 8K buffer 3:5 Rx:Tx split, MII interface.
Nov 12 11:52:57 localhost kernel: MII transceiver found at address 24, status 
786f.
Nov 12 11:52:57 localhost kernel: Using bus-master transmits and whole-frame 
receives.
Nov 12 11:52:57 localhost /etc/hotplug/net.agent: invoke ifup eth0
Nov 12 11:53:58 localhost dhcpcd[9443]: terminating on signal 15 Nov 12 
11:53:58 localhost dhcpcd[9443]: dhcpStop: ioctl SIOCSIFADDR: Inappropriate 
ioctl for device Nov 12 11:53:58 localhost dhcpcd[9443]: dhcpStop: ioctl 
SIOCSIFFLAGS: Inappropriate ioctl for device Nov 12 11:53:58 localhost 
network: Shutting down interface eth0: succeeded
Nov 12 11:53:58 localhost network: Shutting down loopback interface: succeeded
Nov 12 11:54:07 localhost /etc/hotplug/net.agent: NET unregister event not 
supported


-----Kernel messages after Installing 3c59x for the Second time-----------

Nov 12 11:54:35 localhost kernel: 3c59x.c:v0.99X 6/21/2002 Donald Becker, 
[email protected]
Nov 12 11:54:35 localhost kernel: http://www.scyld.com/network/vortex.html
Nov 12 11:54:35 localhost kernel: eth0: 3Com 3c905 Boomerang 100baseTx at 
0xdc80, 00:c0:4f:ae:6c:eb, IRQ 11
Nov 12 11:54:35 localhost kernel: 64K buffer 1:1 Rx:Tx split, 
autoselect/10baseT interface.
Nov 12 11:54:35 localhost kernel: MII transceiver found at address 24, status 
786f.
Nov 12 11:54:35 localhost kernel: Using bus-master transmits and whole-frame 
receives.
Nov 12 11:54:47 localhost sysctl: net.ipv4.ip_forward = 0
Nov 12 11:54:47 localhost sysctl: net.ipv4.conf.default.rp_filter = 1
Nov 12 11:54:47 localhost sysctl: kernel.core_uses_pid = 1
Nov 12 11:54:47 localhost network: Setting network parameters: succeeded
Nov 12 11:54:47 localhost network: Bringing up loopback interface: succeeded
Nov 12 11:54:48 localhost ifup: Determining IP information for eth0...
Nov 12 11:54:48 localhost kernel: eth0: Host error, status e803, FIFO 
diagnostic register 0000.
Nov 12 11:54:48 localhost kernel: eth0: PCI bus error, bus status 00a00029, 
reset had 2000 tick left.
Nov 12 11:54:48 localhost kernel: eth0: Host error, status 8003, FIFO 
diagnostic register 2000.
Nov 12 11:54:48 localhost kernel: eth0: PCI bus error, bus status 00000000, 
reset had 1999 tick left.
Nov 12 11:55:15 localhost dhcpcd[9828]: terminating on signal 2

Thank you,
Anup

-------------------------------------------------
Anup Pemmaiah 
435-512-0935(mobile)
[email protected]
[email protected]
-------------------------------------------------

_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex