Re: Rebuild driver 3C905C-TX-M
Bogdan Costescu <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <Pine.LNX.4.44.0211251547470.16104-100000@kenzo.iwr.uni-heidelberg.de> |
On 25 Nov 2002, Amauris Espinal wrote: > I don't know if this driver work propertly with my nic Card, so, can i > try this??? Err, read the documentation of your distribution. Basically something like: alias eth0 3c59x must be put in /etc/modules.conf, but this is usually done at install time or later on by tools such as kudzu or some network setup tool. As you started on compiling a driver, I thought that you've already passed through these basic steps which would have been needed for 3c90x anyway... -- Bogdan Costescu IWR - Interdisziplinaeres Zentrum fuer Wissenschaftliches Rechnen Universitaet Heidelberg, INF 368, D-69120 Heidelberg, GERMANY Telephone: +49 6221 54 8869, Telefax: +49 6221 54 8868 E-mail: [email protected] _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex