Re: 3c59x AUI and sockets AF_PACKET
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 17 Dec 2002 [email protected] wrote: > > What driver version? > > 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html > 00:09.0: 3Com PCI 3c905B Cyclone 10/100/BNC at 0xe800. Vers LK1.1.16 > PCI: Found IRQ 10 for device 00:0a.0 > 00:0a.0: 3Com PCI 3c900 Cyclone 10Mbps Combo at 0xec00. Vers LK1.1.16 Grrrr, that version isn't showing the vital transceiver configuration information. > vortex-diag.c:v2.05 5/15/2001 Donald Becker ([email protected]) > http://www.scyld.com/diag/index.html > Index #1: Found a 3c905B Cyclone 10/100/BNC adapter at 0xe800. > Transceiver/media interfaces available: 100baseTx 10baseT 10base2 > AUI10baseFL.Transceiver type in use: 10Mbs AUI. > MAC settings: half-duplex. Uhmmm, which NIC are you setting to AUI? The 3c905 or the 3c900? > > What 'vortex-diag' version are you using? > vortex-diag v2.05 5/15/2001 The current version is 2.13, but for these older boards the older diagnostic version is fine. > > What transceiver do you have hooked up? > An HP Transceiver 28685B EtherTwist. > > I am not sure the problem I am facing has anything to do with the > tranciever type: bind() refuses to open the socket, and in my > understanding, it is independant of the cable connection... (isn't it?). It does appear that you have NIC mix-up or a routing proble, not a driver problem. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex