Re: problems w/3c59x on 3CCFE575BT

On Mon, 23 Dec 2002, Donald Becker wrote:

> On Sun, 22 Dec 2002, dean gaudet wrote:
>
> ...
> >  0x030: 0050 04b4 e729 5157 c6fc 0036 4757 6d50
> >  0x038: 3000 0009 0050 04b4 e729 2010 0000 0006
> >  0x040: 32a6 1570 0000 0060 0007 0000 0000 00be
> ...
> >  MII PHY found at address 0, status 280d.
> >  MII PHY 0 at #0 transceiver registers:
> >    2000 280d 0300 e54b 0001 0000 0000 0000
>
> Hmmm, I don't see what is causing the transceiver to only advertise
> half-duplex types.
>
> Does the transceiver change output after doing
>   mii-diag --reset

yeah --

# mii-diag -R eth0
Resetting the transceiver...
Basic registers of MII PHY #0:  3000 2809 0300 e54b 00a1 0000 0000 0000.
 Basic mode control register 0x3000: Auto-negotiation enabled.
 Basic mode status register 0x2809 ... 2809.
   Link status: not established.
   End of basic transceiver informaion.

# mii-diag
Using the default interface 'eth0'.
Basic registers of MII PHY #0:  3000 282d 0300 e54b 00a1 45e1 0003 0000.
 The autonegotiated capability is 00a0.
The autonegotiated media type is 100baseTx.
 Basic mode control register 0x3000: Auto-negotiation enabled.
 You have link beat, and everything is working OK.
 Your link partner advertised 45e1: Flow-control 100baseTx-FD 100baseTx 10baseT-FD 10baseT, w/ 802.3X flow control.
   End of basic transceiver informaion.


but wget on the router itself is still slow...  (i'm guessing the only
reason there's a difference between wget on the router and wget on a
host on another segment routed through this interface is timing of acks...)

-dean
_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex