Re: problems w/3c59x on 3CCFE575BT
Malcolm Scott <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
dean gaudet wrote:
>On Mon, 23 Dec 2002, Donald Becker wrote:
>
>
>
>>I checked this against the reference 3ccfe575bt that I have here at
>>the Scyld offices. Except for the station address and date, the EEPROM
>>contents match the properly working device that I have here.
>>
>>Verify that you are not passing in a module option.
>>
>>
>>
>>> MII PHY 0 at #0 transceiver registers:
>>> 3000 282d 0300 e54b 00a1 45e1 0001 0000
>>>
>>>
>>This transceiver model is slightly different than on my card. Both are
>>TDK 78q2120 parts, but your transceiver is a newer rev. 11 chip (e543
>>vs. e54b).
>>
>>
>
>here's a big long paste so you can be sure i'm doing everything right...
>including setting no options. i ^C'd the wgets after a few seconds
>because they were still clearly going slow.
>
>would it help for me to get the old 3c575_cb driver going and run some of
>these diagnostics?
>
>-dean
>
>
Just an obvious question - are you sure the problem's on your machine,
and not on your webserver ("neemlark")?
--
o Malcolm Scott :: PGP key: http://lcolm.org.uk
/O\ <[email protected]> :: Home: http://advogato.com/person/mascot
~ ~
::: Any sufficiently advanced bug is indistinguishable from a feature.
-- Rich Kulawiec
_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex