RE: Regarding compliation of 3C59x in linux-2.5
Anup Pemmaiah <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
Tee problem that the module gets installed and never comes up is because of a setting in my new kernel. I had enabled CONFIG_PACKET but had not enabled CONFIG_FILTER. After I recompiled the kernel with CONFIG_FILTER evrything worked on fine. I really appreciate your help. Thank you, Anup >===== Original Message From Bogdan Costescu <[email protected]> ===== >On Wed, 9 Apr 2003, Anup Pemmaiah wrote: > >> The 3c59x module gets installed when I say "insmod 3c59x.o". > >At this point do any kind of messages appear in the logs or 'dmesg' output ? >The card should be identified here... You could also try increasing the >debug level to get more messages from the driver. > >> "/sbin/ifup eth0" says "Determining IP information for eth0 ... failed". > >This smells like DHCP. Can you try to assign a static IP and see if the >card is brought up ? > >-- >Bogdan Costescu > >IWR - Interdisziplinaeres Zentrum fuer Wissenschaftliches Rechnen >Universitaet Heidelberg, INF 368, D-69120 Heidelberg, GERMANY >Telephone: +49 6221 54 8869, Telefax: +49 6221 54 8868 >E-mail: [email protected] ------------------------------------------------- Anup Pemmaiah 435-512-0935 [email protected] [email protected] ------------------------------------------------- _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex