Re: 3COM VLAN VLT
Ruben van der Leij <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Organization | Eh? Whats that? |
| Message-ID | <[email protected]> |
+++ Jin [28/04/03 16:48 +0300]: > In vortex-config I sow mac-control reporting, that VLT-VLAN is enabled, but > neighter in mii-control, nor in driver options I sow how to enable it. Did you read the documentation and follow the steps outlined in it? >http://www.candelatech.com/~greear/vlan/cisco_howto.html > >Add some vlans; goto your vlan directory where you previously compiled >vconfig and type: > >vconfig add eth0 2 > >! Little note about VLAN 1. In Cisco systems it is the default VLAN >so you MUST start using vlans from 2. > >This will create device vlan0002 to your system. Linux will think, that it >is just another network device, so you can configure it like any other. Also >you should see the interface by typing > >ifconfig -a > >Lets make some conf on the vlan then: >ifconfig -i vlan0002 10.0.231.1 broadcast 10.0.231.0 netmask 255.255.255.0 >up If you did: what *does* ifconfig -a tell you? -- Ruben van der Leij Albrecht's Law: Social innovations tend to the level of minimum tolerable well-being. _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex