Re: [Fwd: problem with dual 3com card]
Bogdan Costescu <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <Pine.LNX.4.44.0306041950570.20917-100000@kenzo.iwr.uni-heidelberg.de> |
On 4 Jun 2003, maillists (josef radinger) wrote: > 3c59x was loaded with full_duplex debug=7 ... and it gave you what you wanted to: > I'm advertising 0541: Flow-control 100baseTx-FD 10baseT-FD It's only advertising full-duplex modes. > and the switch was on full_duplex Do you mean that you _force_ the switch to full-duplex ? This would actually be consistent with: > Link partner capability is 0000:. > Negotiation did not complete. You can't use autonegotiation at one end (card) and force at the other end (switch). Put the switch into autonegotiation/nway mode and everything should work even without any mii-diag help or kernel parameters... -- Bogdan Costescu IWR - Interdisziplinaeres Zentrum fuer Wissenschaftliches Rechnen Universitaet Heidelberg, INF 368, D-69120 Heidelberg, GERMANY Telephone: +49 6221 54 8869, Telefax: +49 6221 54 8868 E-mail: [email protected] _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex