3c59x full duplex -- no hope?
"Jason Choi" <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <20030711221309.GC17612@panther2> |
Hi, I've read Donald's archive and it seems like there's no way to hard set 3c59x module to full duplex from the kernel module. I can't seem to make even mii-diag -F 100basTx-FD eth0 work either. My switch is set to 100baseTX FD hardset. I've been trying everything. I've tried: device eth(and ethernet) 3c59x --opts="full_duplex=1" device eth(and ethernet) 3c59x --opts="0x200" i've also tried: mii-tool --force=100baseTx-FD eth0. Although it says it works, it doesn't. ------------------------------------------------------------------ Jason Choi AMD CA NVD _______ CAD Design Engineer 915 DeGuigne Ave. \____ | [email protected] Sunnyvale, CA 94088 /| | | Voice: 408-774-7409 | |___| | |____/ \| ------------------------------------------------------------------ _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex