RE: Problems with 3c920, vortex and a 10baseT only router

On Mon, 2 Dec 2002, Donald Becker wrote:

>I should have been clearer: after running this command you should have a
large number of kernel messages that report the status of every packet with
an error.  What are the typical errors?


I have checked the system log, and there is no trace of errors. I have run
again the commands and checked again, and no errors (even if I am losing
over 60% of the packets I send).

Just to be sure I have tried a new cable (remember the CRC errors) and I get
exactly the same results.