RE: Problems with 3c920, vortex and a 10baseT only router

On Tue, 3 Dec 2002, Bogdan Costescu wrote:

> I don't have much hope that this would solve the problem, but could you
try to run the DOS-based utility from 3Com and make sure that both Media and
Duplex are set to "Auto" or "NWAY" ?

I have used the DOS Configuration and Diagnostic Program Version 5.2 from
3Com. Under NIC Configuration, what I get is:

- Network driver optimization: Normal
- Full Duplex: Auto Select (N-WAY)
- Boot PROM: Enabled
- Media Type: Auto Select (N-WAY)
- I/O Port Address: EC80h (PCI)
- Interrupt Level: 11 (PCI)