Re: 3c575_cb-help

On Sat, 7 Dec 2002, franzi wrote:

> I've downloded the last version of pcmcia ,but problems accours always.
> laptop ACER extensa 390 with 64 MB ram .
..
> doing /lib/modules/2.4etc/pcmcia# modprobe 3c575_cb
> 3c59x.c:v0.99q 5/16/2000

That's a rather old version of the driver.  My is that it has been
updated with parts from newer drivers, but I can't be certain what the
changes are.

> shutting down PCMCIA services:cardmgr modules Device or resources busy
> i82365 :devices busy
> cardmgr[643] watching 2 sockets
> cardmgr[643] could not adjust resources:IO ports 0x200-0x27f:Devices or
> resources busy.

Bug in the PCMCIA code...
I find that with 2.4 in-kernel PCMCIA code I must physically remove all
cards before restarting PCMCIA or suspending the laptop.  (Grrrr, this
worked perfectly for years.  Linux did have the best PCMCIA
implementation around, and the MS-Windows people were the ones that had
to remove devices before suspending.)

> eth0:3com 3CCFE575BT Cycl=F2on cardbus at 0x280, 00:10:4b:f5:b9:b1,irq5
>  product code 'NV' rev 07.1 date 10-28-98
>  8K byte-wide RAM 5:3 Rx:Tx split, MII interface
>  eth0:transmit timed out,tx_status 00 status e000.
>  diagnostic: net 0cc2 media a800 dma 000000a0

I believe that the transceiver power needs to be enabled.  The
INVERT_LED_PWR and INVERT_MII_PWR per-card flags were added in the very
next version of the driver, in May 2000.

--=20
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
410 Severn Ave. Suite 210		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993