Re: Re: usr 2450 failure

there is no output to the serial port.

--francois

On Thu, Jan 29, 2004 at 07:54:17AM -0200, Bruno Lopes F. Cabral wrote:
> I'd suggest add a terminal to the serial port to see if
> linux boots/if you lost the configuration area
> 
> that happened to me, once, I entered the unit via terminal,
> ifconfig'd an IP and restore/reflash via network
> 
> Francois Gurin wrote:
> >>My linuxap crashed today and now refuses to boot off the sram when i 
> >>short out jp2.  When it powers on, with or withour jp2 shorted, all the 
> >>lights
> >>go on and the activity led blinks slowly.
> >>
> >>Has anyone seen this behavior before and/or have some advice?
> 
> _______________________________________________
> LinuxAP-dev mailing list
> [email protected]
> http://linuxAP.ksmith.com/mailman/listinfo/linuxap-dev