Re: Re: usr 2450 failure

If all leds are on this is probably not good.

It is possible that cpu is dead If you have osciliscope you can try to check
signals on flash chip.



----- Original Message ----- 
From: "Bruno Lopes F. Cabral" <[email protected]>
To: "Linux Access Point Development" <[email protected]>
Sent: Tuesday, February 03, 2004 7:25 PM
Subject: Re: [LinuxAP-dev] Re: usr 2450 failure


> I have never seen a dead unit, I mean, one that
> shorting JP2 doesn't revive it
>
> sorry, I'm out of suggestions now :~(
>
> !3runo
>
> Francois Gurin wrote:
> > there is no output to the serial port.
> >
> > --francois
> >
> > On Thu, Jan 29, 2004 at 07:54:17AM -0200, Bruno Lopes F. Cabral
> wrote:
> >>I'd suggest add a terminal to the serial port to see
> if
> >>linux boots/if you lost the configuration area
> >>
> >>that happened to me, once, I entered the unit via
> terminal,
> >>ifconfig'd an IP and restore/reflash via network
> >>
> >>Francois Gurin wrote:
> >>
> >>>>My linuxap crashed today and now refuses to boot off
> the sram when i
> >>>>short out jp2.  When it powers on, with or withour
> jp2 shorted, all the
> >>>>lights go on and the activity led blinks
> slowly.
> >>>>
> >>>>Has anyone seen this behavior before and/or have
> some advice?
>
> _______________________________________________
> LinuxAP-dev mailing list
> [email protected]
> http://linuxAP.ksmith.com/mailman/listinfo/linuxap-dev
>