Re: fLASHING PROBLEM

You need to make sure that the image on your card is correct.  That is 
the first step, don't take it for granted.  Read it back and do a diff 
on it from the original image that you wrote to it.  (I had to use a 
utility called wrflash or something like that from the OpenAP/alerios 
directory or some such.)

Once you've got that far it is all a matter of timing on the jumper.  
The jumpering, power on, and unjumpering has to be done at certain 
times.  It took me about 10 tries to do my first one, even though I read 
how to do it.  The next 3 APs I did on the first or second try.

-Scott

gaurav dawra wrote:

> Hi friends
>
> I am trying to flash the access for some time now. I am using MAGIC 
> RAM 2MB SRAM card to flash the access point.  I am using EUMITCOMM 
> Wl11000 rev 3A(USR 2445) and rev 1A. I know Linux AP works well with 
> USR 2450. Does that make any diffence. If anyone have flashed the 
> access point successfully please suggest me. I am presently working 
> for Montana State University Bozeman,MOntana. So if someone living by 
> can help me out in flashing the AP. I will be really thankful.
>
> Best regards,
>
> Gaurav
>
> _________________________________________________________________
> Get a FREE online computer virus scan from McAfee when you click here. 
> http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
>
>
> _______________________________________________
> LinuxAP-dev mailing list
> [email protected]
> http://linuxAP.ksmith.com/mailman/listinfo/linuxap-dev