Re: S3C4510B was Re: isl3893.sf.net project created

Bruno Lopes F. Cabral <[email protected]> [040226]:
> Hello there
> 
> here I have a few 4510b hardwares laying around, but absolutely
> NO CLUE on how to install a bootloader so I can boot linux on
> them

Here's the booter we have used on our board:

http://bh.udev.org/filez/wireless/samsung4510/status/bios-new.bin

Warning: if you don't have the same flash as on the DI614+ board, the
booter should not work.

You should patch the sources of bios-lt so as it understands your flash
chip.

> I also have the JTAG working (using armtool), SERIAL level
> shifter, cross-compiler environment... all them working
> (tested/used with cx84200 port I worked on, but this used
> the SMC bootloader which loads kernel and ramdisk, easying
> my life a lot!)

Ah ah, do you have a Conexant based AP?

> bios-lt uClinux-dist is somewhat confusing for a "newbie"
> (all I wan't was to compile the bootloader and put it into
> a unit), so any help on documenting this simple step would
> be _greatelly_ appreciated!

I will have my board soon, but P2 (in CC:) has it now, he can help if he
can find some time.

I'm building a jtag-usb adaptor (see http://www.ece.uvic.ca/~dgamroth/).

// port is really too slow!

-- 
Benjamin Henrion <[email protected]>
http://bh.udev.org