Re: Re: jtag access on the sc400?

Thumbing through a Dell flyer, I noticed their 300+ MHz Intel XScale 
PDAs.  $199.  (not that I am in the market for any such thing, I had a 
Palm 3C and didn't use it and it broke)

This got me thinking...  Even a "lesser" PDA can probably do a wireless 
bridge quite well...  Granted you might need/want more ports though.  
Nice performance/price point compared to Soekris.  Commodity stuff is so 
nice that way.  If one had 2 PCMCIA slots and could run Linux... there 
you go...

(The Sharp Zaurus is too expensive for this sort of thing...)

Anyone have a resource for a list of LinuxAP-style "distros" and 
hardware to run such distros?
LinuxAP, OpenAP, Pebble Linux, MeshAP, ?, ?
Soekris, WL11000, WRT54G, ?, ?

I wouldn't mind maintaining a page of this stuff, if I had more of a 
complete list.  If there isn't a wiki page out there somewhere, I'll 
start one.

-Scott

Bruno Lopes F. Cabral wrote:

> Hi
>
> I've read reports of ppl using SENAOs on USR2450, before.
>
> perhaps it is time to move on and just port linuxap to
> WRT54G (4MB flash, 16MB RAM)...
>
> thanks for the feedback, though
> !3runo
>
> Keith Smith wrote:
>
>> 200mw Card will likely not work.  Most of these are 5v not 3.3v. 
>
> > The  power supply on the board is pretty light weight
>
> _______________________________________________
> LinuxAP-dev mailing list
> [email protected]
> http://linuxAP.ksmith.com/mailman/listinfo/linuxap-dev