Selon [email protected]:
> Selon "Peter T. Breuer" <[email protected]>:
>
> > "Also sprach denis bonnenfant:"
> > > I compiled and tested a 2.6.10-fr1 kernel, without any problem.
> > > I'm going to stress it a little bit more...
> > >
> And send you the patch !
>
> > > Now I have a problem with enbd!
> > > compilation outside kernel fail. Some makefiles problems!
> >
> > Well, I doubt there is any such problem, but if you don't show me it,
> > I can't tell you anything! Clear out /tmp and run the make again.
> >
> Ok, I will investigate it later!
>
> > > patching succeds, but module enbd doesn't load : cannot allocate major
> > > 43 or something like that.
> >
> > You will have to free major 43 (it's occupied! Look in /proc/devices).
> > Or place enbd on another major with the major= module parameter, if you
> > don't want to free up major 43 for it.
>
> OOPs! It's totally my fault! I hadn't put old nbd out of the kernel !
> now it's ok, i hope... Just the time to compile...
> http://lists.community.tummy.com/mailman/listinfo/enbd
>
enbd make test succeds, except at the end :
ioctl 1 (write direct) testing write illegal ..success (fail Invalid argument)
ioctl 1 (write direct) testing write 0x72c4d611 ..FAIL (Invalid argument)
ioctl 2 (read indirect) testing read 0x72c4d611 ..FAIL (Invalid argument)
ioctl 3 (write + read indirect) testing illegal ..success (fail Invalid
argument)
ioctl 3 (write + read indirect) testing w/r 0x7294bf16 ..FAIL (Invalid
argument)
ioctl 4 (large read indirect) testing ..FAIL (Invalid argument)
ioctl 5 (large write + read indirect) testing ..FAIL (Invalid argument)
echo done
done
anything harmful ?
----------------------------------------------------------------
Lycée Diderot Paris - Ce message est envoyé avec IMP -
lmpx.com only provides a reader for public news (NNTP) servers. It is not
affiliated with the servers or forums shown here and is not responsible for
the content of articles, which is written by their respective authors.