Failsafe on RedHat Linux 7.1

Hi All,

  I am trying to configure FailSafe on RedHat Linux 7.1 . Following are the
configuration I have done

2 Node Cluster with 2 nic's each and one n/w alias each.

The 2 Nic's are configured for different subnets.

I have defined the nodes , created the clusters and when I check the status
of the cluster after starting the failsafe services only one node is shown
as active ( local node) . The other node is shown as inactive.

What could be the problem.

Best regards
Deepu

.



DISCLAIMER: Information contained and transmitted by this E-MAIL is
proprietary to Mascot Systems Limited and is intended for use only by the
individual or entity to which it is addressed, and may contain information
that is privileged, confidential or exempt from disclosure under applicable
law. If this is a forwarded message, the content of this E-MAIL may not have
been sent with the authority of the Company. If you are not the intended
recipient, an agent of the intended recipient or a person responsible for
delivering the information to the named recipient, you are notified that any
use, distribution, transmission, printing, copying or dissemination of this
information in any way or in any manner is strictly prohibited. If you have
received this communication in error, please delete this mail & notify us
immediately at [email protected] Before opening attachments,
please scan for viruses.