Re: How to get a minimize package of Linux FailSafe

Thanks a lot for the helpful answer and i am going to  work it out.

regards



Kashif Shaikh wrote:

>On Fri, 2003-03-28 at 04:58, cqcai wrote:
>
>>Hi:
>>
>>     My Linux FailSafe installation and configuration is nearlly successful.
>>     And now i want to get a minimize package, had better remove all  
>>for  Java and GUI.  Any suggest is very appreciated.
>>
>>     My current installation package is as below:
>>
>>     compat-libstdc++-6.2-2.9.0.16.i386.rpm
>>     heartbeat-stonith-0.4.9-2.i386.rpm
>>     IBMJava118-JRE-1.1.8-3.0.i386.rpm
>>     sysadm_base-client-1.3.7-1.i386.rpm
>>     sysadm_base-dev-1.3.7-1.i386.rpm
>>     sysadm_base-lib-1.3.7-1.i386.rpm
>>
>>     cluster_admin-1.0.4-1.i386.rpm
>>     cluster_services-1.0.4-1.i386.rpm
>>     failsafe-1.0.4-1.i386.rpm
>>
>
>If you want failsafe without the GUI, this is all you need:
>heartbeat-stonith(really needed if you're only using a reset network).
>sysadm_base-lib(used by the CLI programs)
>sysadm_base-dev(needed to compile failsafe).
>
>However, if you want to get adventurous, Failsafe only requires the
>libsysadmUtil and libsysadmParam and saParam.h files.  So you can hack
>the makefiles, and get sysadm really small so you don't need IBMJava118
>or fam to compile it.
>
>Failsafe is composed of sub packages for no practical purposes, so you
>can try hacking the rpm spec file to consolidate cluster_admin,
>cluster_services and failsafe-1.0.4 package into one grand package(which
>is very easy to do).
>
>So in the end, you can get failsafe down to 3 packages, easy to compile
>and easy to install.
>
>Kashif
>
>>
>>
>>    Sincerely
>>
>>
>>
>>
>>_______________________________________________
>>LinuxFailSafe mailing list
>>[email protected]
>>http://lists.community.tummy.com/mailman/listinfo/linuxfailsafe
>>
>
>
>_______________________________________________
>LinuxFailSafe mailing list
>[email protected]
>http://lists.community.tummy.com/mailman/listinfo/linuxfailsafe
>