How to setup STONITH with SSH (later with WTI NPS-230)

Hello,

now I`m running succesfully a cluster of tweo nodes with failsafe frm cvs
with applied patches by Oliver Jehle (newest ones) and some patches from
SuSE (Apache, gcc3 and stonith).
I know about the new CVS-version from yesterday, but the version I`m
running is working fine on Red Hat 7.2 with GLIBC 2.2.4.
I`ve installed the hearbeat-stontih-package too. STONITH with SSH works
fine.
Now my question is, how do I have to set it up in failsafe. I` ve defined
the controller type stonith, owner = other node in my cluster, device =
ssh,othernode ownertype = tty.
But this doesn`t work. "admin reset node XXX" doesn`t work.
I know that SSH/STONITH is not the best combination, but I want to use it
only for test-purposes. If failsafe wokrs fine, I want to buy recommended
hardware that is stonith supported.
Is a WTI NPS-230 working with failsafe? If yes, how do I have to set ip up
in failsafe (settings for syscontroldevice).

Thanks for your good work so far!

CU

	Marc