Re: problems configuring 1280x720 w radeon
Torgeir Veimo <[email protected]>
| Newsgroups | gmane.linux.fbdev.user |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 2004-07-02 at 20:01 +0100, Torgeir Veimo wrote: > I am trying to configure a 1280x720 resolution at 50Hz with a radeon > 9100 QM card. > /var/log/messages at boot time; And dmesg output, for completeness; radeonfb_pci_register BEGIN radeonfb: probed DDR SGRAM 131072k videoram radeonfb: mapped 16384k videoram radeonfb: Invalid ROM signature 0 should be 0xaa55 radeonfb: Retreived PLL infos from BIOS radeonfb: Reference=27.00 MHz (RefDiv=12) Memory=250.00 Mhz, System=200.00 MHz 1 chips in connector info - chip 1 has 2 connectors * connector 0 of type 2 (CRT) : 2300 * connector 1 of type 4 (DVI-D) : 4200 Starting monitor auto detection... radeonfb: I2C (port 1) ... not found radeonfb: I2C (port 2) ... not found radeonfb: I2C (port 3) ... not found radeonfb: I2C (port 4) ... not found radeonfb: I2C (port 2) ... not found radeonfb: I2C (port 4) ... not found radeonfb: I2C (port 3) ... not found radeonfb: I2C (port 4) ... not found radeonfb: Monitor 1 type CRT found radeonfb: Monitor 2 type no found radeonfb: ATI Radeon QM DDR SGRAM 128 MB radeonfb_pci_register END I am using the analog connector on this card, connected to a Sanyo PLV Z2 projector. It advertises wrong EDID data when in PC mode. I can only get it to advertise 1280x720 on the DVI port, but then I am restricted to 60Hz, to get a tearing free picture. This is why I am using the analogue port. -- Torgeir Veimo <[email protected]> ------------------------------------------------------- This SF.Net email sponsored by Black Hat Briefings & Training. Attend Black Hat Briefings & Training, Las Vegas July 24-29 - digital self defense, top technical experts, no vendor pitches, unmatched networking opportunities. Visit www.blackhat.com