Re: Can't mount smb shares using mount.cifs with 2.6.31 kernel
Timothy Normand Miller <[email protected]>
| Newsgroups | gmane.linux.file-systems.cifs |
|---|---|
| Message-ID | <[email protected]> |
On Fri, Oct 16, 2009 at 10:50 AM, Jeff Layton <[email protected]> wrote: > On Fri, 16 Oct 2009 10:32:39 -0400 > > A little. Can you try mounting again with "-o noserverino"? Perhaps > something is wrong with the inode numbers being generated by the server > here... That fixed the problem. It mounts properly now. > If that doesn't help, then maybe also capture some debugging info of > you doing an "ls" in the top-level dir after doing the mount. I can't tell where one set of debug messages end and where the next set starts. Is there something I can do to insert a dummy message into dmesg so I can tell where to start copying? > I doubt this is anything you've done. There were a number of changes in > how inodes are handled under CIFS between 2.6.30 and 2.6.31. It's quite > possible that one of those changes is causing problems with this server. Thanks for the help. Is there anything else I can do to diagnose the cause so it can be fixed permanently? -- Timothy Normand Miller http://www.cse.ohio-state.edu/~millerti Open Graphics Project