Re: JFFS on 2.6.0

Hi,

Sorry, had to send this request again. I am still not able to figure out, 
how to create a JFFS partition on my IDE. :( I am using Kernel 2.6.0, and 
have enabled MTD and JFFS/JFFS2 (noisy level). I still don't get mkfs.jffs. 
Could someone help me with this.

Regards




>
>
>> > Hi,
>> > I am conducting driver-level test to have a performance analysis of 
>>JFFS
>> > File System. I am trying to mount an IDE Block Device as JFFS2, but am
>> > unable to do so.. I am unable to get mkfs.jffs also. :( Could someone 
>>help
>> > me by telling me way to mount a hard disk as JFFS? I am trying this on
>> > Kernel 2.6.0. I have enabled MTD and JFFS/JFFS2 by menuconfig. Are 
>>there any
>> > other parameters also to be enabled? Thanks in advance.
>>
>>Use the 'blkmtd' device, which provides a virtual MTD device using a
>>block device as backing store. Bear in mind that it will give you
>>performance which is violently different from JFFS2 on 'real' flash.
>>
>>If you actually care about performance of JFFS2 on a block device, you'd
>>want to look into using the NAND support to batch writes into 512-byte
>>sectors, etc.
>>
>>--
>>dwmw2
>
>_________________________________________________________________
>Click here for a FREE online computer virus scan from McAfee. 
>http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
>
>
>To unsubscribe from this list: send the line "unsubscribe jffs-dev" in
>the body of a message to [email protected]

_________________________________________________________________
Check out the great features of the new MSN 9 Dial-up, with the MSN Dial-up 
Accelerator. http://click.atdmt.com/AVE/go/onm00200361ave/direct/01/


To unsubscribe from this list: send the line "unsubscribe jffs-dev" in
the body of a message to [email protected]