JFFS2 MTD NAND with two banks

Hi list,

Jffs2 is usable now on our small platform with a 68vz328 (Thanks David for the 
kind support). 

A 32MB Flash chip is mounted within 37 seconds.

Now I would like to add the smart media slot on our board. After reading the 
nand tech document, I still do not understand how to access the smart media 
chip. We use two chips (NAND flash and Smart Media Card)  to share the ALE 
and CLE lines. So how must I adapt the your_hwcontrol mechanism or  do I need 
to write a second independing driver (how could I handle concurrent access in 
that case).

Thanks a lot

regards

Dani



To unsubscribe from this list: send the line "unsubscribe jffs-dev" in
the body of a message to [email protected]