Re: ATI support

On Tue, 2007-03-20 at 11:51 -0500, Justin Conover wrote:

> After you install the driver, run the following:
> 
>  yum install ati-x11-drv
> aticonfig --initial
> aticonfig --overlay-type=Xv
> edit xorg.conf and drop in the bottom
> 
> Section "Extensions"
>         Option  "Composite" "Disable"
> EndSection
> 
> Section "ServerFlags"
>         Option  "AIGLX" "off"
> EndSection

After doing the above, and also even adding a dri section as well as a
Load dri in the module section, this is what I get below when running
glxgears..

[mike@scrappy ~]$ glxgears
Xlib:  extension "XFree86-DRI" missing on display ":0.0".
1696 frames in 5.2 seconds = 327.441 FPS

Do I need to reboot again or is restarting xfs good enough?

-- 
Mike Chambers
Madisonville, KY

"Sex is like air, it's not important unless your not getting any!"