Making changes to a statically build driver

--001517511032c106480464675b0a
Content-Type: text/plain; charset=ISO-8859-1
Content-Transfer-Encoding: 7bit

Hello all:
               I made some changes to the e1000 kernel driver.  I then
recompiled the kernel without any issue.  How can I tell if the change
actually went through?  Again, this driver has been statically built into
the kernel.  Is there a way to test that a change went through without have
to setup a test environment?

-- 
Ezra Taylor

--001517511032c106480464675b0a
Content-Type: text/html; charset=ISO-8859-1
Content-Transfer-Encoding: quoted-printable

Hello all:<br>=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0=A0 I made some change=
s to the e1000 kernel driver.=A0 I then recompiled the kernel without any i=
ssue.=A0 How can I tell if the change actually went through?=A0 Again, this=
 driver has been statically built into the kernel.=A0 Is there a way to tes=
t that a change went through without have to setup a test environment?<br c=
lear=3D"all">
<br>-- <br>Ezra Taylor<br>

--001517511032c106480464675b0a--