2.6.8 kernel and SWXCR (Mylex DAC960) controller

After many months of trial and error.  (Actually having the time to really
dig into it more).
I've managed to interpret the DAC960.c source code to determine what the
devfs names might be under the 2.6.8 kernel.
FYI  (my root partition is the 2nd partition on the 1st Logical RAID 5
drive) (2 Logical volumes total)

My /etc/fstab
#Linux 2.6
/dev/rd/host0/target0/part1     none    swap    sw      0 0
/dev/rd/host0/target0/part2     /       ext3    noatime 0 0
/dev/rd/host0/target1/part1     /export ext3    noatime 0 0


#Linux 2.4
#/dev/rd/disc0/part1    none    swap    sw      0 0
#/dev/rd/disc0/part2    /       ext3    noatime 0 0
#/dev/rd/disc1/part1    /export ext3    noatime 0 0

My aboot.conf
0:2/boot/kernel-2.4.21-alpha-r12 root=/dev/rd/disc0/part2 console=ttyS0
console=tty0 initrd=/boot/initrd-2.4.21-alpha-r12 init=/linuxrc
2:2/boot/kernel-2.6.8-gentoo-r6 root=/dev/rd/host0/target0/part2
console=ttyS0 console=tty0 initrd=/boot/initrd-2.6.8-gentoo-r6 init=/linuxrc

The key I found for this to work properly was to make certain the devfs file
system was properly compiled into the kernel and automounted the relevant
portions of my .config.

My .config file:
CONFIG_DEVFS_FS=y
CONFIG_DEVFS_MOUNT=y

Brian Parkhurst
[email protected]


--
[email protected] mailing list