miata and samba3

Hello,

I am new to this list, luckily not new to Linux and Gentoo (I386) a bit
newer to Alpha.

I am and was able to get a PWS 500au (miata) booting and running (saw
some problems in the archive about booting maybe I have some answers if
still needed).

The problem I run into is with Samba (3.0.9-r1 as well 3.0.10) it
compiles well (fails on smbtorture, but ok) runs fine and seems oke but
when trying to place a file on the fileshare ,for a windows client, it
fails warning about the network name no longer available, still creates
an empty file, when looking in the log file it states a INTERNAL ERROR
Signal 11 and stating it should be submitted as a bug, but with the same
system running on a dual-xeon no problem.

are there any alpha + samba users and which config (versions) do you
run? any hints to a solution?

for reference:
PWS 500au (PWS 433a up next) from stage1
kernel 2.4.21-alpha-r9 
samba 3.0.9-r1 / 3.0.10
make.conf:
  CFLAGS="-mcpu=ev56 -O3 -pipe" and tried "-mcpu=ev4 -pipe" for samba
  MAKEOPTS="-j2"
  USE="-X alsa cdr ethereal mysql oss ldap"

With regards,

Edwin Barendse


--
[email protected] mailing list