Re: miata and samba3

I think you could attach to the samba process with gdb
and then when the segfault occured, gdb should catch
it. Of course unless you have a bit of programming
experience and know how to debug a little, none of
that is going to help much anyway. 

I would try looking at this if I could, but I am
almost out of disk space on my box at the moment. I
don't think I have enough room to emerge samba right
now.

Jeff

--- Jean-Sébastien Guay <[email protected]> wrote:

> Hi Jeff,
> 
> In my case, here's the relevant part of my make.conf
> :
> 
> CFLAGS="-mieee -O2 -mcpu=ev56 -pipe"
> CHOST="alphaev56-unknown-linux-gnu"
> CXXFLAGS="${CFLAGS}"
> MAKEOPTS="-j2"
> 
> I think that's relatively conservative.
> 
> Other than that, how do I get a core file? I assume
> there's something I 
> need to enable so that programs will dump core when
> a segfault occurs, 
> but I don't know what. But other than providing a
> core file and 
> answering questions about my config, there isn't
> much I can do to zero 
> in on the problem since I don't know how to use gdb
> (to get anything 
> meaningful, in any case...)
> 
> Thanks for your help,
> 
> J-S
> 
> -- 
> ___________________________________________
> Jean-Sébastien Guay   [email protected]
>              http://whitestar02.webhop.org/
> 
> 
> 
> -- 
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.300 / Virus Database: 265.8.7 - Release
> Date: 2005/02/10
> 
> 
> --
> [email protected] mailing list
> 
> 



		
__________________________________ 
Do you Yahoo!? 
Meet the all-new My Yahoo! - Try it today! 
http://my.yahoo.com 
 


--
[email protected] mailing list