As2000 update

Hello all,

I had posted a few weeks back requesting help with installing
on a AS/2000 and had promised to get back with how it went

this is how I did it, there are probably mistakes/ better ways
of doing this, I would be interested in hearing any comments

to recap, I could boot the system wiht 1.4 CD, but not with the
2005.0 one. Since I was not sure if I could use a 2005.0 stage
after booting with 1.4 kernel/glibc etc., I used stage 2 from
1.4 to install the basic packages. the gentoo documentation
was a great help here

after getting a current portage snapshot and linking to 2005.0/2.4
profile, emerge (from 1.4) would fail with message
>> update type "slot move" not recognized

after much trial and error, linking to default-alpha-2004.0
allowed emerge to go forward but with a whole bunch of warnings/
errors. this allowed update to portage, python and I coudl link to
2005.0/2.4 and emerge would go forward after manually putting
in a world file (it helped to have a x86 gentoo system for
reference to figure out file locations etc. here)

initially I was using the CD to boot and then chrooting, and then
I just copied over the kernel/initrd/modules from the 1.4 CD and
used that as the entry in aboot.conf. compiling a current kernel
was a challenge since each new try could go over 2 hours, before
I eventually reduced the kernel config ot a minimum (this has only
128M) and still get it to boot

once that hurdle was over, updating the system was the next step.
here the problem was that random segmentation faults would happen
and the emerge would stop in between. eventually over many retries
most of the system was updated and there was a binutils update
and glibc update. trying to ugrade these actually led to more
frequent errors. one approach that worked better here (for me) was
to use "ebuild xyz.ebuild compile install qmerge" which updated the
pkg with fewer faults (typically)

one issue possibly was that I had -mcpu=ev45 in the CFLAGS since
/proc/cpuinfo gave cpu as ev45. changing it to ev5 seemed to have
improved the random failures

repeating the process eventually got most of the pkgs compiled with
the new binutils and am now trying to redo binutils/gcc/glibc
to make sure that is stable. assuming that goes fine, next step
would be to move to 2.6 kernel

few points that I noted on the way

gcc-3.3.2-r7 seem to ignore the -fortan USE flag and installs g77
anyway

glibc update, when it went through fully and started to remove the
build directory it caused filesystem issues and gave messages such
as "journal aborted" etc and next reboot forced an fsck which needed
manual intervention to clean up the system (ext3). I haven't tried
with features="keepwork" to see if this can be avoided

thanks for reading this far, all comments are appreciated

best regards, Mathew


-- 
[email protected] mailing list