Radeon driver not working
Daiajo Tibdixious <[email protected]> Wed, 31 May 2017 14:29:01 +1000
| Newsgroups | gmane.linux.gentoo.amd64 |
|---|---|
| Message-ID | <CAC4mkfs0kCLOkWvfp_5JYn7hw=DOKBZ+MvEa8XaPgEdggmdwNw@mail.gmail.com> |
--94eb2c05d7f81583900550ca5c58 Content-Type: text/plain; charset="UTF-8" For a while now I've been logging into root & doing "modprobe radeon" after which the screen will blank, then come back at a much higher resolution. (as an aside, where do I put modules to autoload?) Since the last reboot nothing happens. SDDM/KDE will not start. I have checked all the radeon settings in the kernel, & tried booting off a previous kernel with no change. If I login to my user account & do "startx" that also fails. I took the cover off the machine & the GPU fan is spinning. It's dusty but not too bad. I've run out of ideas. To me it looks like a HW fault but I don't know how to check the GPU. It's still visible in lspci & console mode works (with tiny # lines & width). (IDK if this will be text or html, the setting is not visible on phone) --94eb2c05d7f81583900550ca5c58 Content-Type: text/html; charset="UTF-8" Content-Transfer-Encoding: quoted-printable <div dir=3D"auto">For a while now I've been logging into root & doi= ng "modprobe radeon" after which the screen will blank, then come= back at a much higher resolution. (as an aside, where do I put modules to = autoload?) Since the last reboot nothing happens. SDDM/KDE will not start.<= div dir=3D"auto"><br></div><div dir=3D"auto">I have checked all the radeon = settings in the kernel, & tried booting off a previous kernel with no c= hange.=C2=A0</div><div dir=3D"auto"><br></div><div dir=3D"auto">If I login = to my user account & do "startx" that also fails.</div><div d= ir=3D"auto"><br></div><div dir=3D"auto">I took the cover off the machine &a= mp; the GPU fan is spinning. It's dusty but not too bad.</div><div dir= =3D"auto"><br></div><div dir=3D"auto">I've run out of ideas. To me it l= ooks like a HW fault but I don't know how to check the GPU. It's st= ill visible in lspci & console mode works (with tiny # lines & widt= h).=C2=A0</div><div dir=3D"auto"><br></div><div dir=3D"auto">(IDK if this w= ill be text or html, the setting is not visible on phone)=C2=A0</div></div> --94eb2c05d7f81583900550ca5c58--