Re: Python stops working after upgrade

2013.Május 30.(Cs) 01:39 időpontban PaX Team ezt írta:
>
> python should work with EMUTRAMP enabled only, there's no need to disable
> MPROTECT (unless there's more breakage than libffi but then i'd need more
> information on it). note also that the above PT_PAX value tries to turn
> on EMUTRAMP in softmode (beyond not disabling it in hardmode) but it'll
> fail to actually do so since PAGEEXEC/SEGMEXEC are not turned on at the
> same time. IOW, paxctl -zx is enough, no need for -zEx.
>

Disabling mprotect was needed for openoffice's pyuno bridge to function
long ago. It may be unnecessary these days. I have to retest.
Enabling emutramp on the binary seems to kill python on the other hand,
while it seems to operate correctly with "e" only.
-- 
dr Tóth Attila, Radiológus, 06-20-825-8057
Attila Toth MD, Radiologist, +36-20-825-8057