Re: SELinux conversion questions

Thank you.  I confirmed that portage had been running under python 2.7.

I found the problem, though...  I'd set POLICY_TYPES="targeted" in
make.conf, and therefore portage installed policies into
/etc/selinux/targeted only.  However, running /usr/sbin/selinuxconfig and
catting /etc/selinux/config both made clear that 'strict' was a requirement.

I've worked through it by setting POLICY_TYPES="strict targeted", then
rebuilding selinux-base and selinux-base-policy.  I feel like this is
another documentation bug - the user should be told either that 'strict' is
initially required in make.conf, or that /etc/selinux/config must be edited
before the selinux-base-policy install.

Anyway, thanks again.  I'm sure I'll be back...

Erik


On Sun, Feb 23, 2014 at 8:00 PM, Dustin C. Hatch <[email protected]>wrote:

> On 02/23/2014 06:18 PM, Erik Mackdanz wrote:
> > I'm attempting to convert my laptop to SELinux using the conversion
> > guide, and I've run into a few snags with documentation.  I've consulted
> > the troubleshooting page, archives and forums, and now am reaching out
> > directly.
> >
> > 1) When I get to the world update ('emerge -uDN world'), every package
> > fails at install with 'Failed to set SELinux security labels.'  Don't I
> > also need 'FEATURES="-selinux"' for that step (like the preceding step)?
> >
> I am fairly sure FEATURES=selinux is pretty important at this step; this
> is where you are re-installing all packages with SELinux support, and
> the security labels are supposed to be set.
>
> I had the same problem, though, on a recent conversion. In my case, the
> problem was emerge was using python3, but the selinux module only exists
> for python2. Try setting python2.7 as your default interpreter, or
> re-emerge portage with USE=python2. The latter is what I did and now
> everything works fine.
>
> --
> ♫Dustin
> http://dustin.hatch.name/
>
>