Re: selected from my XFree86.0.log

Well, you can see from the log that the module "mga_hal" cannot be
found. It looks like a missing module from your kernel compilation,
re-check your kernel configuration.

  Regards / Per-Erik

On Tue, 2002-08-20 at 11:42, Bob Lockie wrote:
> 
> Does anybody see anything wrong with this?
> 
> XFree86 Version 4.2.0 / X Window System
> (protocol Version 11, revision 0, vendor release 6600)
> Release Date: 18 January 2002
> Build Operating System: Linux 2.4.19 i686 [ELF] 
> Module Loader present
> 
> (WW) Open APM failed (/dev/apm_bios) (No such file or directory)
> (--) PCI:*(1:0:0) Matrox MGA G200 AGP rev 1, Mem @ 0xcd000000/24, 0xcfefc000/14, 0xcf000000/23, BIOS @ 0xcfee0000/16
> (--) Assigning device section with no busID to primary device
> (--) Chipset mgag200 found
> (**) MGA(0): Depth 24, (--) framebuffer bpp 32
> (==) MGA(0): RGB weight 888
> (II) Loading sub module "mga_hal"
> (II) LoadModule: "mga_hal"
> (WW) Warning, couldn't open module mga_hal
> (II) UnloadModule: "mga_hal"
> (EE) MGA: Failed to load module "mga_hal" (module does not exist, 0)
> (II) MGA(0): Matrox HAL module not loaded - using builtin mode setup instead
> (--) MGA(0): Chipset: "mgag200"
> (==) MGA(0): Using AGP 1x mode
> (--) MGA(0): Found and verified enhanced Video BIOS info block
> (**) MGA(0): VideoRAM: 8192 kByte
> 
> (**) MGA(0): Default mode "1024x768": 78.8 MHz, 60.1 kHz, 75.1 Hz
> (--) Depth 24 pixmap format is 32 bpp
> (==) MGA(0): Default visual is TrueColor