Re: can't set up network during install: Chicken Re: [gentoo-newbies] can't set up network during install: Chicken
Ujwal S.Sathyam <[email protected]> Sun, 13 Oct 2002 11:54:37 -0700
| Newsgroups | gmane.linux.gentoo.newbies |
|---|---|
| Message-ID | <[email protected]> |
On 2002-10-13 11:57:20 -0700 3.2.3 <[email protected]> wrote: > "Ujwal S.Sathyam" wrote: >> >> Hello, >> >> I am trying to install Gentoo Linux using the UT2003 LiveCD on my Dell box and ran into a problem pretty quickly: >> >> I can't get networking up during the installation phase. I have two network cards: >> >> 1. 3COM 905C (3c59x driver) >> 2. Linksys LNE100 (tulip driver) >> >> Unfortunately, neither module is on the CD. I can't find the Linux kernel sources on the CD either, so I can't recompile it. > > tulip is a pcmcia net driver. pcmcia is missing from the cd. see the > following link for how to fix: > > http://forums.gentoo.org/viewtopic.php?t=14894#86393 > http://forums.gentoo.org/viewtopic.php?t=15075#84424 > My card is not a PCMCI card, it's PCI. I thought tulip was a driver for the DEC chip. What about the 3COM 905C card. That is actually my primary interface eth0. Thanks, Ujwal